| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| GT tilt bar removal http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=73869 |
Page 1 of 1 |
| Author: | bluesky2012 [ Sat Jun 01, 2019 10:49 am ] |
| Post subject: | GT tilt bar removal |
I’ve got my powerhead off for a cam swap and figured I should go ahead and replace the tilt bar bolt because mine has quite a bit of play. It’s definitely wallowed out a bit inside so it’s stuck in there good. Gave it a few hits and it won’t budge, so does anyone have a creative method to get it out? Sent from my iPhone using Tapatalk Pro |
|
| Author: | lastchance [ Sun Jun 02, 2019 11:13 am ] |
| Post subject: | Re: GT tilt bar removal |
Check your pm's Sent from my SM-G975U using Tapatalk |
|
| Author: | MaXXis85 [ Mon Jun 03, 2019 7:12 am ] |
| Post subject: | Re: GT tilt bar removal |
the swivel bracket will have cut grooves in it. You need to support frame then work it out. Hitting it wont always be the best way. |
|
| Author: | bluesky2012 [ Fri Jun 07, 2019 9:19 pm ] |
| Post subject: | Re: GT tilt bar removal |
Took an impact and a big freakin mallet but it’s out and replaced. Definitely worth replacing far more frequent than I did. Only $23 to replace. Sent from my iPhone using Tapatalk Pro |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|