| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| boat http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=2&t=768 |
Page 1 of 1 |
| Author: | huvik [ Sat Feb 21, 2009 9:10 pm ] |
| Post subject: | boat |
i think the boat i will be buying will be a high sided 1860 or 2060 with dual 36 pd. there are a few questions i have 1. can u buy a pd boat with tapered chines 2. can u get three bladed props for this engine and if so are they better than 2 blade 3. how fast would a setup like this go 4. approx how much fuel is used? 5. how much would the boat squat with the duals. 6. how bad is the propeller walk since both props are spinning th same way? thanks |
|
| Author: | huvik [ Sun Feb 22, 2009 6:33 pm ] |
| Post subject: | Re: boat |
|
|
|
| Author: | Brinkleydog [ Mon Feb 23, 2009 2:53 pm ] |
| Post subject: | Re: boat |
| Author: | Damon Silva [ Mon Feb 23, 2009 3:04 pm ] |
| Post subject: | Re: boat |
I had and 18/54 with duals awhile back. The boat was not a PD boat but ran 36PD's on it. You would be better off just calling me than me try to type all of this info out. Damon Silva 409-313-2997 Southeast Texas Pro-Drive |
|
| Author: | Brinkleydog [ Mon Feb 23, 2009 3:16 pm ] |
| Post subject: | Re: boat |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|