I have a 2008 mud buddy hyper35 up hyper drive. Sometimes my engine will get stuk in neutral. I will move the switch back and forth and nothing then all of a sudden it goes into gear. I already put on a new switch. How can I fix this?

i had the same problem with mine the other day but mine would not go in gear . you need to pull your clutch cover off and make sure one of your wires are not loose on your clutch itself .

Make sure u have 12volts before it goes into the belt housing before you go through the trouble of opening the belt housing.

I had an issue like this with mine (2010) and I had a bad clutch breaker(?) It is the two prong party that completes the circuit. Was a 5 dollar fix.

Sent from my SCH-I535 using Tapatalk

Low voltage, prob the culprit

This only happens every once in a while not all the time. Can I check the voltages when it is still working or do I have to wait until it us not working to check.
I figured the switch was. Working because when I have engaged it won't start.
Also if anyone has any pics that would help. I'm not very mechanically inclined.

What mine would do, is when in gear and running, it would go into neutral.

Sent from my SCH-I535 using Tapatalk

I had the same issue, picked up another on/off/momentary on switch from radio shack (most of them have them in a drawer somewhere). Fixed the problem, but I would check the voltage also, just in case it's more of an issue than a bad switch.