MudmotorTalk.com
http://www.mudmotortalk.com/mmt_v2/

Gator tail 35 jetting
http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=64382		 Page 1 of 1
Author:  Pigglet [ Sun Nov 01, 2015 6:08 pm ]
Post subject:  Gator tail 35 jetting
I ran my gtr35 for the first time today and checked the plugs and are white as can be. Its bone stock except for macs exhaust. Anyone know what jet size I should go with or other possible things to change in the carb to richen it up? This is my first mud boat/motor so I'm totally green to it.
Author:  brycecheramie [ Sun Nov 01, 2015 6:17 pm ]
Post subject:  Re: Gator tail 35 jetting
Author:  Pigglet [ Sun Nov 01, 2015 6:20 pm ]
Post subject:  Re: Gator tail 35 jetting
The porcelain is white. It should be tan
Author:  Will C [ Sun Nov 01, 2015 8:12 pm ]
Post subject:  Re: Gator tail 35 jetting
By looking at your pic i would leave jetting alone. If u do heads etc then i might bump it abit,
Author:  Pigglet [ Mon Nov 02, 2015 6:14 pm ]
Post subject:  Re: Gator tail 35 jetting
Ok I just thought it was really lean since it wasn't a nice tan color. I'm only gettin 4080rpms and a buddy said I should be revvin 4200.
Author:  Will C [ Mon Nov 02, 2015 6:21 pm ]
Post subject:  Re: Gator tail 35 jetting
The base ring of the plug is black, your fueling is close enough that adding fuel prob wont make more power, lots of things can vary rpm from rig to rig
Author:  deadbird8 [ Mon Nov 02, 2015 7:09 pm ]
Post subject:  Re: Gator tail 35 jetting
The porcelain will be white. It will not be tan unless you are idling a lot. The porcelain colors from the base upward.
Author:  Pigglet [ Mon Nov 02, 2015 7:27 pm ]
Post subject:  Re: Gator tail 35 jetting
10 4 thanks for the replies guys. I'll leave it be until I do some mods :D
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/