| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Pattern for torquing head bolts? http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=65748 |
Page 1 of 1 |
| Author: | ibfishin [ Wed Feb 10, 2016 6:38 pm ] |
| Post subject: | Pattern for torquing head bolts? |
Anybody tell me what the pattern should be? Sent from my SM-G920V using Tapatalk |
|
| Author: | SCmudder7071 [ Wed Feb 10, 2016 6:55 pm ] |
| Post subject: | Re: Pattern for torquing head bolts? |
Bottom left, top center, bottom right, top left, bottom center, top right |
|
| Author: | JD145 [ Wed Feb 10, 2016 7:00 pm ] |
| Post subject: | Re: Pattern for torquing head bolts? |
http://www.backwaterperformancesystems. ... th=117_126 |
|
| Author: | ibfishin [ Wed Feb 10, 2016 7:13 pm ] |
| Post subject: | Re: Pattern for torquing head bolts? |
Thanks... another question. I noticed the head gasket has a slightly raised area around the perimeter of the cylinder and oil galleys. Should that surface face down against the block or up against the head? Sent from my SM-G920V using Tapatalk |
|
| Author: | deadbird8 [ Thu Feb 11, 2016 6:04 am ] |
| Post subject: | Re: Pattern for torquing head bolts? |
| Author: | ibfishin [ Thu Feb 11, 2016 6:23 am ] |
| Post subject: | Re: Pattern for torquing head bolts? |
Thanks... haven't tried to put them on yet, I just looked at the gasket and noticed both sides were not the same. Probably would have figured it out pretty quickly during the install. Sent from my SM-G920V using Tapatalk |
|
| Author: | MaXXis85 [ Thu Feb 11, 2016 6:37 am ] |
| Post subject: | Re: Pattern for torquing head bolts? |
Everyone will have there own way, I torque them in 2 stages. Working from the center bolts out. |
|
| Author: | deadbird8 [ Thu Feb 11, 2016 8:28 pm ] |
| Post subject: | Re: Pattern for torquing head bolts? |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|