| Author |
Message |
|
Rambeaux_67
MMT Pro Member
Joined: Tue Mar 24, 2015 9:12 am Posts: 71
|
 GTR Bearings
Quick question here.. The bearings in the steering neck on a GTR, can they be bought anywhere or is a Gatortail only part? I know in my harley steering neck a 1" trailer bearing works perfect so i wasnt sure if the same would go for this.
|
| Tue Apr 12, 2016 9:35 am |
|
 |
|
MaXXis85
MMT Elite Member
Joined: Wed Jan 14, 2009 7:23 am Posts: 6233 Location: Tarkington, TX
|
 Re: GTR Bearings
They are bushings.
_________________ Bayou Surface Drive 337-351-0362 Tarkington, TX 77327
|
| Tue Apr 12, 2016 10:37 am |
|
 |
|
Rambeaux_67
MMT Pro Member
Joined: Tue Mar 24, 2015 9:12 am Posts: 71
|
 Re: GTR Bearings
So im guessing they are a dealer only part then?
|
| Tue Apr 12, 2016 11:11 am |
|
 |
|
MaXXis85
MMT Elite Member
Joined: Wed Jan 14, 2009 7:23 am Posts: 6233 Location: Tarkington, TX
|
 Re: GTR Bearings
It will be the easiest place to get them. Is your tower really sloppy wit movement?
_________________ Bayou Surface Drive 337-351-0362 Tarkington, TX 77327
|
| Tue Apr 12, 2016 12:27 pm |
|
 |
|
Rambeaux_67
MMT Pro Member
Joined: Tue Mar 24, 2015 9:12 am Posts: 71
|
 Re: GTR Bearings
Yeah, its pretty bad. I picked up a used motor that runs like a top just needs these bushings or bearings changed and it will be good. It doesnt look like a bad job at all to do. Im going to give gatortail a ring in a bit and see what they say though.
|
| Tue Apr 12, 2016 12:57 pm |
|
 |
|
BayouStateHunter
MMT 1000 Club
Joined: Sat May 16, 2009 1:04 pm Posts: 2037 Location: On da Northshore -- Louisiana
|
 Re: GTR Bearings
They going to tell you to not worry about it. They all get slop in them over time.
_________________ 1860 GTB/35GTR CC w/ Hoyt Stage 1 - bowfishin'/rodnreel/duckhunting
|
| Tue Apr 12, 2016 10:50 pm |
|
 |
|
Rambeaux_67
MMT Pro Member
Joined: Tue Mar 24, 2015 9:12 am Posts: 71
|
 Re: GTR Bearings
He was actually very helpful and we got the bushings ordered and on the way.
|
| Wed Apr 13, 2016 7:28 am |
|
 |
|
Rambeaux_67
MMT Pro Member
Joined: Tue Mar 24, 2015 9:12 am Posts: 71
|
 Re: GTR Bearings
Changed the bushings out last night and it was breeze! The shaft in the tower was rusted really bad so i gave it a good cleaning and greased it good then put it all back together. There is still a little slop in the bottom bushing but nowhere near what it had.
|
| Wed Apr 27, 2016 6:37 am |
|
 |
|