| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Is my motor stock http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=71634 |
Page 1 of 1 |
| Author: | Bayloreast [ Tue Nov 28, 2017 7:07 pm ] |
| Post subject: | Is my motor stock |
I have a 2015 gator tail 35 in the water it doesn't bounce the rev limiter till about 4700 rpm is that factory or is there something done to the engine I bought the engine used and never thought to ask |
|
| Author: | brycecheramie [ Tue Nov 28, 2017 7:12 pm ] |
| Post subject: | Re: Is my motor stock |
Sounds like you have 4750 rev limit coils on the motor. Are you running those rpm’s consistently? Or just when the prop comes out the water? |
|
| Author: | bluesky2012 [ Tue Nov 28, 2017 7:13 pm ] |
| Post subject: | Is my motor stock |
You are turning 4700 rpms in the water? If so, then no I doubt it is stock. The stock CDI coils do limit rpms at 4700 rpms OOW but I highly doubt you're running those RPMs in the water with a stock motor unless your prop is worn like crap. What speeds are you seeing and do you have it trimmed right? Sent from my iPhone using Tapatalk Pro |
|
| Author: | Bayloreast [ Wed Nov 29, 2017 9:13 am ] |
| Post subject: | Re: Is my motor stock |
The prop is in the water at 4700 rpm but trimmed a little high I run best trimmed down at about 4400 to 4500 rpm that's where I run consistently it goes about 24 to 26 mph |
|
| Author: | brycecheramie [ Wed Nov 29, 2017 9:26 am ] |
| Post subject: | Re: Is my motor stock |
Sounds like you’ve got the lower pitched prop with a stock motor. I could be wrong though. |
|
| Author: | Will C [ Wed Nov 29, 2017 11:39 am ] |
| Post subject: | Re: Is my motor stock |
Or wasted prop |
|
| Author: | brycecheramie [ Wed Nov 29, 2017 11:56 am ] |
| Post subject: | Re: Is my motor stock |
| Author: | ibfishinb [ Wed Nov 29, 2017 12:24 pm ] |
| Post subject: | Re: Is my motor stock |
That is alot of RPM's to be going nowhere very fast. Sent from my SM-G920V using Tapatalk |
|
| Author: | Bayloreast [ Wed Nov 29, 2017 1:31 pm ] |
| Post subject: | Re: Is my motor stock |
Should I try a new prop what should I get |
|
| Author: | bluesky2012 [ Wed Nov 29, 2017 3:12 pm ] |
| Post subject: | Re: Is my motor stock |
Try a big blade Sent from my iPhone using Tapatalk Pro |
|
| Author: | Bayloreast [ Wed Nov 29, 2017 10:25 pm ] |
| Post subject: | Re: Is my motor stock |
Has anyone ran the hammer prop or is it to much prop |
|
| Author: | Will C [ Wed Nov 29, 2017 10:55 pm ] |
| Post subject: | Re: Is my motor stock |
Prob too much |
|
| Author: | MaXXis85 [ Thu Nov 30, 2017 6:05 am ] |
| Post subject: | Re: Is my motor stock |
Hammers are NOT for stock motors. Your prop is worn more than likely. |
|
| Author: | Quack N Stack [ Sun Dec 03, 2017 6:56 pm ] |
| Post subject: | Re: Is my motor stock |
For a 35 that does sound high. However i do run my best speeds around 4600-4700 rpm on a stock 37. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|