| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Can anyone verify on delta lvl 2 valve lash http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=72959 |
Page 1 of 1 |
| Author: | jz_meinert [ Tue Sep 04, 2018 9:20 am ] |
| Post subject: | Can anyone verify on delta lvl 2 valve lash |
Just had installed a delta lvl 2 on my 40hdr with HD rods. Was told valve lash should be set .006 on the intake and .008 on the exhaust. Is this correct because I've been told both that and .005 all around. Sent from my iPhone using Tapatalk |
|
| Author: | Russ [ Tue Sep 04, 2018 9:44 am ] |
| Post subject: | Re: Can anyone verify on delta lvl 2 valve lash |
Told by who? If delta says something specific, use that. #CFFITR #TheGhostBoat #whoneedsphysicsihaveamudmotor |
|
| Author: | jz_meinert [ Tue Sep 04, 2018 10:44 am ] |
| Post subject: | Re: Can anyone verify on delta lvl 2 valve lash |
I'm not listing names but two people in the industry very well known said no, one well known that installed it said yes. Delta said yes also lol just my mind wondering is all. Sent from my iPhone using Tapatalk |
|
| Author: | JLACOUR [ Tue Sep 04, 2018 10:58 am ] |
| Post subject: | Re: Can anyone verify on delta lvl 2 valve lash |
Set cylinder #1 to 6 & 8 thou and cylinder #2 to 5 thou. |
|
| Author: | Will C [ Tue Sep 04, 2018 7:26 pm ] |
| Post subject: | Re: Can anyone verify on delta lvl 2 valve lash |
Regardless of where u set them make sure and touch them up around 10 hrs. Soo many folks overlook this |
|
| Author: | jz_meinert [ Tue Sep 04, 2018 7:44 pm ] |
| Post subject: | Re: Can anyone verify on delta lvl 2 valve lash |
| Author: | prodrivinggatortail [ Wed Sep 05, 2018 7:58 am ] |
| Post subject: | Re: Can anyone verify on delta lvl 2 valve lash |
| Author: | jz_meinert [ Wed Sep 05, 2018 11:59 am ] |
| Post subject: | Re: Can anyone verify on delta lvl 2 valve lash |
| Author: | jz_meinert [ Wed Sep 05, 2018 1:15 pm ] |
| Post subject: | Re: Can anyone verify on delta lvl 2 valve lash |
Sorry just looking at others opinions not distrusting the specs I was given Sent from my iPhone using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|