MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/
Prodrive Hydraulic Trim http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=3&t=73413	Page 1 of 1

---

Author:	mdycrk [ Sat Jan 05, 2019 1:03 pm ]
Post subject:	Prodrive Hydraulic Trim
Started having some issues with my hydraulic trim today on my 13 prodrive. When I hit the trim up or down switch, it’s clicking then will kick in to move the motor up or down. I’m thinking it’s the solenoid going bad most likely? Anyone have any thoughts or suggestions before I just buy a new one?

---

Author:	Swamp Wader [ Sat Jan 05, 2019 10:05 pm ]
Post subject:	Re: Prodrive Hydraulic Trim
Give PD a call.

---

Author:	brycecheramie [ Sun Jan 06, 2019 11:50 am ]
Post subject:	Re: Prodrive Hydraulic Trim

---

Author:	mdycrk [ Sun Jan 06, 2019 1:50 pm ]
Post subject:	Re: Prodrive Hydraulic Trim
Gen 3.

---

Author:	EGood [ Sun Jan 06, 2019 4:23 pm ]
Post subject:	Re: Prodrive Hydraulic Trim
My gen 3 has done the same thing a few times in the past couple of weeks. I keep pushing my luck and just keep going hunting instead of fixing it. I’m following this to so hopefully one of these smart mud motor guys will post an exact switch and solenoid that I need to buy. Sent from my iPhone using Tapatalk

---

Author:	brycecheramie [ Sun Jan 06, 2019 4:26 pm ]
Post subject:	Re: Prodrive Hydraulic Trim
You can call prodrive and they will get you a new switch, if you have the older model, Or I think you can tell them you want to switch to solenoid and a cheaper switch and they have a kit to do it.

---

Author:	mdycrk [ Sun Jan 06, 2019 5:14 pm ]
Post subject:	Re: Prodrive Hydraulic Trim
This is the part number and stuff on what I’m having an issue with. When I hit my switch, I can feel it clicking in here. Also it does it when I hit the trim on my motor or my remote trim switch on my grab bar.

---

Page 1 of 1	All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/