|
FAQ
• Login
|
|
It is currently Tue Apr 23, 2024 2:12 am
|
|
Page 1 of 1
|
[ 5 posts ] |
|
Front Crank Bearing replacement notes
Author |
Message |
Will C
MMT Sponsor
Joined: Fri Jan 10, 2014 1:16 pm Posts: 2107 Location: Gladewater TX
|
Front Crank Bearing replacement notes
I had a nice block that needed a bearing. Yes that bearing is about 250$ i did this on 2 junk blocks first. I drilled a couple holes in a dirtbike stand so the block pins fit into so the block could lay flat. 1 layer of cardboard for cushion. I warmed the block with a torch till about 225. Using my cam bearing tool i drove the bearing towards rear of block. Worked good with the block warm. On the first try with no heat I cracked the block hitting the driver with a big o hammer. With heat they moved much nicer. I built a piece of aluminum to position the block upside down when installing bearing. When time for install they must go in from the back side using the rear cover as a lineup. Watch bearing alignment tang, depth of bearing and oil feed hole alignment. I added a few drops of the green retaining only to about half the bearing. I stayed away from the oil feed hole with it. Bearing was in freezer, block was still warm. Bearing tapped in nicely
You do not have the required permissions to view the files attached to this post.
|
Wed Nov 13, 2019 1:18 am |
|
|
Will C
MMT Sponsor
Joined: Fri Jan 10, 2014 1:16 pm Posts: 2107 Location: Gladewater TX
|
Re: Front Crank Bearing replacement notes
.
You do not have the required permissions to view the files attached to this post.
|
Wed Nov 13, 2019 1:19 am |
|
|
MaXXis85
MMT Elite Member
Joined: Wed Jan 14, 2009 7:23 am Posts: 6233 Location: Tarkington, TX
|
Re: Front Crank Bearing replacement notes
Ive done a few. Briggs has a specialty tool I bought from them . Makes it SUPER easy. I like your style
_________________ Bayou Surface Drive 337-351-0362 Tarkington, TX 77327
|
Wed Nov 13, 2019 6:38 am |
|
|
Will C
MMT Sponsor
Joined: Fri Jan 10, 2014 1:16 pm Posts: 2107 Location: Gladewater TX
|
Re: Front Crank Bearing replacement notes
If we could get a bearing for 50 bucks then i would have invested in the briggs stuff, but at the cost of the bearings,,,, dam
|
Wed Nov 13, 2019 3:12 pm |
|
|
Will
MMT Elite Member
Joined: Fri Jul 08, 2011 1:54 pm Posts: 8133
|
Re: Front Crank Bearing replacement notes
Yeah, those bearings are ridiculously high
_________________ Before the internet, the majority of the village idiots stayed in their villages.
|
Wed Nov 13, 2019 5:55 pm |
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 210 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|