I'm looking for some information on Hydro-Turf, thickness, colors, and patterns. I will be putting this in my blind boat. I've been told that this stuff is the best. I have seen the price and it's pretty high. Just wanted to know if anyone is getting a good deal on this from any special manufactures.

http://hydroturf.com/products.php?cat=S ... Hydro-Turf

I'm guessing that this is as cheap as you can buy it.

yeah i just ordered two of the big sheets 47x86 i believe it is for my boat and it was only like 150 with no adhesive on the back so ill have to glue it down but it is nice and that is cheap for that. it would have taken me 3 or 4 of the small sheets to do my boat and they are 80 dollars a sheet from gator trax.

Got mine from Gator trax. GT brown with adheasive for 80/sheet.

all i can say is you are dumb if you dont order this stuff, its .5 mm thinner than the original and yes it does have course brush strokes in it but oh well, me and white1 put it in my boat last night and it came out great.

and the 80$ a sheet from gator trax is smaller sheets than what i got, it took only 2 of these sheets to do my whole boat, including the halfbox and the center bench seat.

get dap contact adheisive, red can gel kind. works great. read directions on can and thats all you need to know.

I just got done putting Hydroturf down. I took my time and I think it came out great. Used the 3M stuff.

The bow was the last thing I did, which I did today, and it was a PITA because I didn't put the HT under the lights, etc. They have rivets which would have bee hard to refind the holes again. I made a template of the lights made out of notebook paper and applied the sketch to the HT. Trimmed everything dry, except for rear edge, took a filet knife after it was glued down and ran it down the edge. Smooth as sh*t.