| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Building my first mm boat! Help please!! http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=11858 |
Page 1 of 1 |
| Author: | CaptainEric84 [ Sun Aug 22, 2010 10:54 pm ] |
| Post subject: | Building my first mm boat! Help please!! |
As soon as I sell my current boat (17x56 w/ 40 ETEC $7500) I will be getting Charles Lenard to build me a boat. I thinking of going with 2048 with a smooth bottom and putting a 36pd on her. Anyone know how this will run. Would a 18 or 19' be better? Also I was thinking about putting two 4' runners on the bottom to help with sliding. Any advice or suggestions will be appreciated. Thanks in advance |
|
| Author: | Team Camo [ Mon Aug 23, 2010 10:54 pm ] |
| Post subject: | Re: Building my first mm boat! Help please!! |
Sounds like it's gonna be a good setup. Instead of runners on the bottom, get him to do tapered chines instead of square. |
|
| Author: | CaptainEric84 [ Thu Aug 26, 2010 9:06 pm ] |
| Post subject: | Re: Building my first mm boat! Help please!! |
| Author: | Team Camo [ Thu Aug 26, 2010 9:39 pm ] |
| Post subject: | Re: Building my first mm boat! Help please!! |
My 1644 has round chines and sittin still it drafts about 8" with a 35 on the back. |
|
| Author: | JBREAUX [ Fri Aug 27, 2010 8:41 am ] |
| Post subject: | Re: Building my first mm boat! Help please!! |
Captain Eric, Where are you located? |
|
| Author: | MaXXis85 [ Fri Aug 27, 2010 9:25 am ] |
| Post subject: | Re: Building my first mm boat! Help please!! |
| Author: | CaptainEric84 [ Fri Aug 27, 2010 5:59 pm ] |
| Post subject: | Re: Building my first mm boat! Help please!! |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|