| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| looks like I'll be cutting a transom... http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=12921 |
Page 1 of 1 |
| Author: | Joe M [ Thu Oct 07, 2010 9:48 pm ] |
| Post subject: | looks like I'll be cutting a transom... |
Just got the panzer back to TX. I'm either gonna have to cut the transom down or get the slow drive switched to a long un. What do yall think? |
|
| Author: | Nathan [ Thu Oct 07, 2010 11:03 pm ] |
| Post subject: | Re: looks like I'll be cutting a transom... |
Could you add a hunt deck with a lower motor mount, or use a manual jack plate mounted low on the transom? Nathan |
|
| Author: | Shadow [ Fri Oct 08, 2010 6:08 am ] |
| Post subject: | Re: looks like I'll be cutting a transom... |
Post a picture Joe. If you can afford to get the prodrive changed over.... DO IT! You will like having a tall transom. |
|
| Author: | Joe M [ Fri Oct 08, 2010 6:53 am ] |
| Post subject: | Re: looks like I'll be cutting a transom... |
I'll put up a few after I get out of class. Switching a pro-drive is around $200 ? Peck told me what it was but i forgot, does anyone know off hand? I can cut a transom for free! |
|
| Author: | DeathMetalDukk [ Fri Oct 08, 2010 7:35 pm ] |
| Post subject: | Re: looks like I'll be cutting a transom... |
| Author: | Gatorpoint [ Sat Oct 09, 2010 6:44 am ] |
| Post subject: | Re: looks like I'll be cutting a transom... |
Tall transom motor! |
|
| Author: | POKER1 [ Sat Oct 09, 2010 6:52 pm ] |
| Post subject: | Re: looks like I'll be cutting a transom... |
Tall................ |
|
| Author: | Joe M [ Sat Oct 09, 2010 7:49 pm ] |
| Post subject: | Re: looks like I'll be cutting a transom... |
Screw it.... Pratt and Whitney turbine is in the works. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|