How long does it take to bend a lil sheet of aluminum?
Im ready to see those bigger hulls for the copperhead, may put the purchase on one when the funds get right.

Can we see a sneak?

me too! cant wait to see what they have come up with

is that with the 12hp?

Thats a fine lookin lil boat

What gauge is the aluminum?

Looks like Sanford and Son's yard

I wish I could have these jons in production right now, problem is getting the materials. To build this boat we need 72" wide x 15-17' long .100 5052 sheets of aluminum in order to make these a one peice hull. Problem is noone in the US has these sheets in stock since October and the mills have not run any yet. Have 20 sheets on order since October, were to be in in December, now it looks like Jan. We should have these hulls in production for Feb 1 delivery.

Sorry for the delays.

We are very happy with the results from the 1540, it ran great, carried load great and was really stable for a 40" bottom boat. We have not been in a hurry to post up test results because we hate to put stuff out there when we can't get production going due to lack of available materials. We are close enough now to getting materials that we will start booking orders for Feb delivery.

Thanks,


Paul Willging

any vid on the boat running if so lets see it

I bet that light ass boat would fly with a 25 hp Mercury