| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Cutting on a southfork http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=14478 |
Page 1 of 1 |
| Author: | 625browning [ Sat Dec 11, 2010 3:30 pm ] |
| Post subject: | Cutting on a southfork |
I want to cut out the center seat. Will this weaken the center part? What i want to do is mount a low profile truck tool box in its place. Would it be better to bolt it or weld it? |
|
| Author: | kibb [ Sat Dec 11, 2010 3:39 pm ] |
| Post subject: | Re: Cutting on a southfork |
Why not just buy a piano hinge and modify the seat already in there? Cut out some of the top of the seat, get a piece of aluminum plate, break it, and install it. That would be a cleaner look while keeping some of the integrity of the original seat. |
|
| Author: | Bream Busta [ Sat Dec 11, 2010 4:26 pm ] |
| Post subject: | Re: Cutting on a southfork |
| Author: | 625browning [ Sat Dec 11, 2010 6:41 pm ] |
| Post subject: | Re: Cutting on a southfork |
Thats an idea, iam just fishing around i cant wait to get started any other ideas throw them at me. Ive been checking out the tinboats.net out and come up with some ideas |
|
| Author: | Brasso [ Wed Mar 02, 2011 10:17 pm ] |
| Post subject: | Re: Cutting on a southfork |
Sorry to jack your thread man, but can anyone tell me if you can completely cut that middle bench seat out? I want an open floor plan with only one half driver box and a gun box.. where can I find a gun box, and half seat, and would I weld them in or what? |
|
| Author: | HUNT4DEER [ Thu Mar 03, 2011 7:16 pm ] |
| Post subject: | Re: Cutting on a southfork |
i cut the top on both the seats. the middle has a live well in the center now i have two small storage on each side. the rear is wide open lots of storage. had two lide broke and covered them with carpet full lenth piano hinge its great. looks good and doesnt get hot in the sun. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|