MudmotorTalk.com
http://www.mudmotortalk.com/mmt_v2/

GTR pulls a little
http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=18746		 Page 1 of 1
Author:  marshcreaper [ Mon May 23, 2011 5:45 pm ]
Post subject:  GTR pulls a little
alright gator tail people mine pulles a little and throws a rooster tail 20ft to the side if i tweek that torque tab a little that otta fix it ????
Author:  WestEndAngler [ Mon May 23, 2011 5:51 pm ]
Post subject:  Re: GTR pulls a little
balance your load first these boat/motor setups are very sensitive to weigh distribution. You can add a torque tab or slightly bend your skeg. Torque tab works for me
Author:  dog walker [ Mon May 23, 2011 5:51 pm ]
Post subject:  Re: GTR pulls a little
Load placement in the hull can have alot to do with tiller torque. Was the boat empty or did you have stuff or people in it? Sometimes mounting the motor slightly off center,usually an inch can help. Sounds like you may have the motor trimmed too high if you are throwing a rooster tail that big.
Author:  marshcreaper [ Mon May 23, 2011 6:12 pm ]
Post subject:  Re: GTR pulls a little
Author:  dog walker [ Mon May 23, 2011 6:14 pm ]
Post subject:  Re: GTR pulls a little
Author:  marshcreaper [ Mon May 23, 2011 6:20 pm ]
Post subject:  Re: GTR pulls a little
Author:  marshcreaper [ Mon May 23, 2011 6:32 pm ]
Post subject:  Re: GTR pulls a little
tab
Author:  marshcreaper [ Mon May 23, 2011 6:48 pm ]
Post subject:  Re: GTR pulls a little
i think if i put a cresent wrench on it ill be okk ????
Author:  dog walker [ Mon May 23, 2011 6:56 pm ]
Post subject:  Re: GTR pulls a little
It's pulling away from you? If so then try bending back towards the skeg a lil bit and try it out. A large crescent should work.
Author:  marshcreaper [ Mon May 23, 2011 7:01 pm ]
Post subject:  Re: GTR pulls a little
Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/