| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| go devil flotation removal http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=19772 |
Page 1 of 1 |
| Author: | hookpuller [ Wed Jul 06, 2011 9:47 am ] |
| Post subject: | go devil flotation removal |
I'm in the process of buying a used 1644 go devil. The boats a 2001, based on some of the discussion i've read I'm assuming the flotation is "waterlogged". Has anyone removed the flotation personally that can give me some direction? Is there a way to check the condition of the flotation to see if it needs to be replaced? Any information would be much appreciated. |
|
| Author: | Team Camo [ Wed Jul 06, 2011 9:50 am ] |
| Post subject: | Re: go devil flotation removal |
The floor is simple, just drill out the rivets & remove it, the front deck & rear pods have to be cut on to remove the flotation. PM Robn1020 about it, he had his redone a couple years ago. |
|
| Author: | Old School [ Wed Jul 06, 2011 10:06 am ] |
| Post subject: | go devil flotation removal |
According to some u will be putting yourself and others in danger if u remove it. I have been traumatized from reading those posts, don't know if I'll ever to get in my boat again. |
|
| Author: | craig [ Wed Jul 06, 2011 10:12 am ] |
| Post subject: | go devil flotation removal |
| Author: | Old School [ Wed Jul 06, 2011 1:34 pm ] |
| Post subject: | go devil flotation removal |
It's not my theory, just passing along what was posted earlier |
|
| Author: | SammyC [ Thu Jul 07, 2011 9:58 pm ] |
| Post subject: | Re: go devil flotation removal |
When u pull the floor up it will probably be painfully obvious that its water and fuel logged. I took a 2x6 and beat the strips out. Be careful its hot and you will need plenty of beer and or water. this is at least what i encountered |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|