|
|
FAQ
• Login
|
|
It is currently Sun Jun 22, 2025 3:00 pm
|
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
nate0985
MMT Member
Joined: Sun Aug 07, 2011 5:35 pm
Posts: 38
|
 20" transom work So I bought a boat with 20" sides and transom but when I got it, the transom had already been cut to 18". My copperhead will not even begin to push that boat because of the angle of the prop in the water. Now I am considering getting my transom cutdown to 15.5 or 16", not by me but someone that knows what they are doing. Is this a good idea, both structurally and safety?
_________________
1540 with a 16 hp copperhead
Dual 8ft stiffy's
Blood on the decks
"Probably shouldn't mess with that, it was set up by someone who actually knew how to turn a wrench!"---DAD
|
| Thu Jul 12, 2012 9:52 am |
|
|
|
cb5331
MMT Super Elite Member
Joined: Fri Dec 18, 2009 8:10 pm
Posts: 16915
Location: Rowlett, TX
|
Re: 20" transom work If done properly, it will be fine.
|
| Thu Jul 12, 2012 10:11 am |
|
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 173 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|