MudmotorTalk.com
http://www.mudmotortalk.com/mmt_v2/

semi v mud boat
http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=34907
Page 1 of 1

Author:  1st-n-last59 [ Sun Dec 02, 2012 6:45 pm ]
Post subject:  semi v mud boat

I want to build a new hull. It's gonna b a 1850-54 with a huntdeck and triple taper chine 3/16" bottom with 1/8" sides. Been seeing a few hulls with the semi v front rake. I want to put that on my hull but not 100% sure how to go about pulling it off. Any help would b greatly appreciated.

Author:  scatters boy 316 [ Mon Dec 03, 2012 7:44 am ]
Post subject:  Re: semi v mud boat

The mod v only come down to the rake, it is said to help in rougher weather ( 2 foot swells etc) and they do very well in timber due to the pointed bow, other than that they just look cool

Author:  rob_E [ Mon Dec 03, 2012 7:53 am ]
Post subject:  Re: semi v mud boat

go to www.explorebeavertail.com there are plenty of good pics to get you started. Lots of guys dog beavertail boats because they are slower with the pods but i think they are some of the coolest looking rigs around.

Author:  1st-n-last59 [ Mon Dec 03, 2012 11:01 am ]
Post subject:  Re: semi v mud boat

Well I hunt alot in timber and buckbrush. And my wife likes the idea that it will keep some of the water out of the boat in windy waters. I think they look good also.

Author:  scatters boy 316 [ Mon Dec 03, 2012 12:42 pm ]
Post subject:  Re: semi v mud boat

Personally I don't like the beaver tail boats because they have no rake. Excel, gatortrax , and gatortail as well as the custom builds make hulls with mod v rakes. But higher sides also help with rough water and spray

Author:  odass [ Mon Dec 03, 2012 7:56 pm ]
Post subject:  Re: semi v mud boat

Do you get into some big waves down there? It would definitely help in timber. But is probably going to hard to build that v unless you can talk to somebody that can give you the outline on how to cut the material.

Author:  1st-n-last59 [ Mon Dec 03, 2012 9:00 pm ]
Post subject:  Re: semi v mud boat

I'm pretty sure I can wing it and get it done. Just lookin for a little insite from someone that has a bit more experience with building a v rake or has been around one that has looked at it closely. I haven't seen one in person. I have a pretty good ability to build something if I put my mind to it just don't have forever to cut fit look repeat. Plus I don't wanna waste a hull butchering it up. Not enough time or money. I will only b home for a short period of time and would like to get it done.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/