Does anybody see a problem occurring if i were to remove these two dividers out of my skiff


Sent from my iPhone using Tapatalk

Probably not. I would cut them out and see if the sides flex. If the flex too much get a welder to slap some braces on it and roll with it!


Sent from my beeper

Might flex some, but you could always add catwalks.

Sent from my XT1080 using Tapatalk

Only problem I see is you won't be getting any more training for the 5 meter hurdles!

You have a lot of cross bracing above your longitudinals. Your gunnel rail looks pretty stout. It's a skiff. So, the sides are already "stressed"....if that's a good word to use??? Make your cuts like shown in the photo below. 3"-4" on bottom, leave an inch or so on top. Use what you already have to your advantage. If you want to step it up just a bit, lap a piece of 3/4" angle over the cut and stitch weld it.

dusu2enu1.jpg