| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Boat question?? http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=50193 |
Page 1 of 1 |
| Author: | mudmarshall [ Sun Feb 09, 2014 5:47 pm ] |
| Post subject: | Boat question?? |
Does anybody see a problem occurring if i were to remove these two dividers out of my skiff Sent from my iPhone using Tapatalk |
|
| Author: | North LA Hunter [ Sun Feb 09, 2014 7:05 pm ] |
| Post subject: | Re: Boat question?? |
Probably not. I would cut them out and see if the sides flex. If the flex too much get a welder to slap some braces on it and roll with it! Sent from my beeper |
|
| Author: | OwenDickeson [ Sun Feb 09, 2014 7:08 pm ] |
| Post subject: | Re: Boat question?? |
Might flex some, but you could always add catwalks. Sent from my XT1080 using Tapatalk |
|
| Author: | BlueShamu [ Sun Feb 09, 2014 7:41 pm ] |
| Post subject: | Re: Boat question?? |
Only problem I see is you won't be getting any more training for the 5 meter hurdles! You have a lot of cross bracing above your longitudinals. Your gunnel rail looks pretty stout. It's a skiff. So, the sides are already "stressed"....if that's a good word to use??? Make your cuts like shown in the photo below. 3"-4" on bottom, leave an inch or so on top. Use what you already have to your advantage. If you want to step it up just a bit, lap a piece of 3/4" angle over the cut and stitch weld it. dusu2enu1.jpg |
|
| Author: | cb5331 [ Sun Feb 09, 2014 8:15 pm ] |
| Post subject: | Re: Boat question?? |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|