| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Round chine build ? http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=57228 |
Page 1 of 1 |
| Author: | genson [ Wed Oct 08, 2014 6:52 pm ] |
| Post subject: | Round chine build ? |
Has anyone built a round chine boat theirselves other than the builders if so how did yall roll the chine |
|
| Author: | da go get'er [ Wed Oct 08, 2014 9:38 pm ] |
| Post subject: | Re: Round chine build ? |
Come-along the two sides together |
|
| Author: | odass [ Thu Oct 09, 2014 6:23 am ] |
| Post subject: | Re: Round chine build ? |
I would think you would have to build a jig or something to hold the form. Sounds hard, I'm sure that's why most don't build them. |
|
| Author: | da go get'er [ Thu Oct 09, 2014 8:43 am ] |
| Post subject: | Re: Round chine build ? |
| Author: | genson [ Thu Oct 09, 2014 11:20 am ] |
| Post subject: | Re: Round chine build ? |
I was thinking something like yhat maybe using a peice of pipe for ur radius |
|
| Author: | BayouBuster [ Thu Oct 09, 2014 12:34 pm ] |
| Post subject: | Re: Round chine build ? |
Tack in some temporary braces to hold the sides where you want them whike you get the transom and deck in. Just make sure its squared. |
|
| Author: | Capt. JJ [ Thu Oct 09, 2014 2:01 pm ] |
| Post subject: | Re: Round chine build ? |
I've built a bunch of them over the years. PM me and I'll tell you what you need to know. Justin |
|
| Author: | Old School [ Thu Oct 09, 2014 7:43 pm ] |
| Post subject: | Re: Round chine build ? |
Chine roller. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|