| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| GD 1844 Transom Height Change http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=64042 |
Page 1 of 1 |
| Author: | wheeler [ Tue Oct 06, 2015 2:26 pm ] |
| Post subject: | GD 1844 Transom Height Change |
I just bought a GD 1844 with a short transom (16") and no motor. After some seaching on here it sounds like a tall transom is the best way to go with a surface drive. Question is what is the best transom height for a Mudd Buddy 35hp surface drive? The boats gunnels are at 19" so I could raise the transom to meet with that or go an inch above for a 20" transom. From a fabrication standpoint 19" would be the easiest, but I want to do what is best. Also, any experience with raising transoms on GD boats would be helpful,ie what worked and what did not. |
|
| Author: | Gchelette [ Tue Oct 06, 2015 8:07 pm ] |
| Post subject: | Re: GD 1844 Transom Height Change |
Jack plate Sent from my iPhone using Tapatalk |
|
| Author: | cmk07c [ Wed Oct 07, 2015 7:06 pm ] |
| Post subject: | GD 1844 Transom Height Change |
I run a short transom on a go devil boat with big block surface drive. Save yourself the headache and money and just get a short transom motor. Sent from my iPhone using Tapatalk |
|
| Author: | brycecheramie [ Wed Oct 07, 2015 9:52 pm ] |
| Post subject: | Re: GD 1844 Transom Height Change |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|