I would too if you have one for a PD?
| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Drake1...3 blade prop http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=970 |
Page 1 of 1 |
| Author: | Tulsa_Woody [ Fri Mar 06, 2009 10:33 am ] |
| Post subject: | Drake1...3 blade prop |
Drake1, I seem to remember that you were using or testing a 3 blade on a Gator-tail. If so, how was the performance. Was it a MB or something you had made custom? I don't run in the thick mud or veggies and would love to have some vibration and torque reduced. Woody |
|
| Author: | shotgunslb [ Fri Mar 06, 2009 12:07 pm ] |
| Post subject: | Re: Drake1...3 blade prop |
I would too if you have one for a PD?
|
|
| Author: | drake1 [ Sat Mar 07, 2009 12:23 am ] |
| Post subject: | Re: Drake1...3 blade prop |
Runs great, carries a load, great hole shot, good speed, not much tiller torque and not much vibration. Mr. Hopkins built it for me. It is a 11X10 with round blades and some cup. Stock motors will need a 11X9 in my opinion. It does decent in the mud and decent in some grass. It is a good hard bottom clean water prop. I am trying to get him to build me a 4 blade in 11X9. More blades in the water the more prop you can get out of the water to blow yourself out of the hole on hard bottom. I hav a two blade that can do it right now but I have found the smaller the prop the smoother and easier it is to drive. |
|
| Author: | Drake_35GTR [ Sat Mar 07, 2009 2:52 am ] |
| Post subject: | Re: Drake1...3 blade prop |
How did it do in reverse?? |
|
| Author: | drake1 [ Sat Mar 07, 2009 7:39 am ] |
| Post subject: | Re: Drake1...3 blade prop |
Better than any two blade I run. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|