| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| putting a mud motor on with my blind http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=4&t=9954 |
Page 1 of 1 |
| Author: | nitrousneil [ Mon May 31, 2010 10:43 am ] |
| Post subject: | putting a mud motor on with my blind |
im wanting to put a surface drive motor on my boat,its a 2005 grizzley with a gooseview blind i'll provide the link, my problem is this blind is a x-bar scissor type blind and a long tail wont work because of how they hang into the boat but the motor im looking at is a mud buddy i think its a mini lite i forgot to ask, but how far into the boat do these hang, my blind comes back to where the suppports go from the transom to the sides. here is a pic of the motor and the blindhttp://www.bigriverprodrive.com/blinds.htm |
|
| Author: | cb5331 [ Mon May 31, 2010 10:48 am ] |
| Post subject: | Re: putting a mud motor on with my blind |
Don't know for sure on the mudbuddy's, but I have a prodrive with the same blind. No problems at all, just have to turn the motor to the side to lift the blind. |
|
| Author: | Team Camo [ Mon May 31, 2010 2:11 pm ] |
| Post subject: | Re: putting a mud motor on with my blind |
If that's the motor in the pic, it's not a mini lite, it's one of the older, original hyper drive models. The way the handle is made, it should accomodate for the X-frame on the blind, but like CB said, ya can always just turn it all the way to one side. |
|
| Author: | brlcla [ Mon May 31, 2010 2:31 pm ] |
| Post subject: | Re: putting a mud motor on with my blind |
on most of these motors the handle free floats so it can be used in the boat and when you get ready to lift the blind you can just lift the handle up vertical along side the motor... |
|
| Author: | nitrousneil [ Thu Jun 03, 2010 4:22 pm ] |
| Post subject: | Re: putting a mud motor on with my blind |
thanks for the help fellas, do any of you know if this blind will work with a long tail? i dont think it will it will hang into the boat too far. |
|
| Author: | Team Camo [ Thu Jun 03, 2010 6:04 pm ] |
| Post subject: | Re: putting a mud motor on with my blind |
Uh, negative Ghost Rider. A LT will go just as far, probly further into the boat. You could make a new handle for the lt so that it comes from the top of the motor instead of the bottom. Then it should clear the blind, if that's the route ya wanna take. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|