| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| mud buddy service http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=12550 |
Page 1 of 1 |
| Author: | catfishin01 [ Tue Sep 21, 2010 12:41 pm ] |
| Post subject: | mud buddy service |
Anyone know what to do on the shaft and belt after 50 hours? i am told that it needs to be serviced after 50 hrs. i dont want to over grease the shaft and wonder what the belt tension should be. thanks for the help |
|
| Author: | HUNT4DEER [ Wed Oct 13, 2010 9:31 am ] |
| Post subject: | Re: mud buddy service |
buy a tension tool and check the belt. loosen the bolts a little and and adjust. a rubber mallet or dead blow hammer is nice to have when doing this. i wont explane, you will figure it out when you do it. pull the plug out of the housing end bearing housing and pump grease in the zerk until some graese comes out of the plug hole. leave the plug out and run the motor until it warms up a little. some graese will come out of the hole. wipe the graese of and replace the plug. done. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|