Ok I have a 23GTR and I have a nomad prop but I need one to run the federal reserves down in Texas. I called baumans in houston and they said they could do whatever I needed done. I am going the make the prop 9 1/4 diameter but not sure what pitch it needs to be. Its a 35hp grr prop so its a 11 pitch right now. What would be the best pitch so im not all up on my rev limiter. Not much mud running either so that's not much or a factor.

10 pitch and cup it to get it tuned!! Try about a 1/2" of cup

10 understandable. But a 1/2 inch of cup f-me really? I was projecting 9 1/2 pitch with factory style cup being it gonna have be copied from a new prop just a 91/2 diameter.

Tell Louis to call me...

These props have a progessive pitch.

Did you talk to Louis or his brother? His brother works on all the props. Their Dad Louis Sr. ran the shop & supplied my families barge business for years.

They do good work. But fine tuning a prop is very difficult. They have the stock 35 GTR prop they can work from. I supplied it to them.

Ok Coe but I told them that you brought a factory new prop in there to get the dimensions off of that one. Did they not do that Coe? I did mentioned your name when asking if that could do this!

Ok that WEA!

Dude just call me I have tried posting a reply 3x now & its a PITA when my text gets deleted because of stupid max user errors!

Posted that the same time you posted your second reply. Didn't see it.

If its the same federal marshes I hunt in Southeast Texas you cant run a prop over 9 inches in diameter.Are you having the diameter cut down also?

Reread my first post! thats what i'm doing is cutting it to a 9 1/4 then repitching it. talked to hoyt at gator-tail and he sad if anything i need to go up in pitch from a 10 to a 11 or 12. but he said to run it first with a hunt load to see how it did cut down to 9 1/4 diameter. cause he said the 23gtr;s tend to bog with a hunt load and with the smaller prop i might like the fast rev i get with the load.