| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| 35 GDSD http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=22114 |
Page 1 of 1 |
| Author: | koda4u [ Wed Sep 14, 2011 8:25 pm ] |
| Post subject: | 35 GDSD |
Has anyone tried a 2 blade MB 12.5 big prop instead of the 3 blade GD prop. Any advantages or stay with 3 blade? |
|
| Author: | LA Mudder [ Thu Sep 15, 2011 8:54 am ] |
| Post subject: | Re: 35 GDSD |
When i had my GDSD i did, i didnt see any advantages. my stock 3 blade ran the best in all of my conditions |
|
| Author: | koda4u [ Thu Sep 15, 2011 9:17 am ] |
| Post subject: | Re: 35 GDSD |
Can you run a big 2 blade GT prop on a 35 Go-devil SD. will it fit? |
|
| Author: | Robn1020 [ Thu Sep 15, 2011 11:12 am ] |
| Post subject: | Re: 35 GDSD |
| Author: | deltaduckmaster [ Thu Sep 15, 2011 11:23 am ] |
| Post subject: | 35 GDSD |
| Author: | koda4u [ Thu Sep 15, 2011 11:29 am ] |
| Post subject: | Re: 35 GDSD |
I am just interested in :if a two is better overall... need to push a load and for speed. If a 3 is fine I will go that route on a new one. thanks |
|
| Author: | Robn1020 [ Thu Sep 15, 2011 12:23 pm ] |
| Post subject: | Re: 35 GDSD |
| Author: | Robn1020 [ Thu Sep 15, 2011 12:24 pm ] |
| Post subject: | Re: 35 GDSD |
Giga runs 2 blade gd prop. I prefer 3 blade. |
|
| Author: | Gigafowl [ Thu Sep 15, 2011 3:01 pm ] |
| Post subject: | Re: 35 GDSD |
| Author: | bbb [ Thu Sep 15, 2011 3:28 pm ] |
| Post subject: | 35 GDSD |
| Author: | mudduck1 [ Thu Sep 15, 2011 4:27 pm ] |
| Post subject: | Re: 35 GDSD |
I run a 35 GDSD the motor has a Mikuni Carb, Marsh-mellow exhaust, and Iron Mountain heads, I have run both 2 and 3 blade props. During Gator season I had 3 guys in my boat, I weigh 270, and both of my buddies weigh around 240. we had a 8 1/2 foot gator, trolling motor 2 batteries cooler, and all our other misc. gator gear on a 1660 GDSD boat and according to the GPS we were running 23-24 in deep water 26-27 in the skinny stuff, with a 3 blade prop. I find the three blade works the best for me as I can run full throttle and not worry about hitting the rev limiter with a 2 blade I can only run about 3/4 throttle . I also find the 3 blade has better hole shot, but I have to replace it about every 30-40 hours to maintain optimum performance, if I am running in the thick crap. |
|
| Author: | koda4u [ Thu Sep 15, 2011 6:13 pm ] |
| Post subject: | Re: 35 GDSD |
thanks guys... I'm going back with the 3 blade GD |
|
| Author: | koda4u [ Thu Sep 15, 2011 6:38 pm ] |
| Post subject: | Re: 35 GDSD |
any suggestions on where to buy a 3 blade gd? 260 is going price ? |
|
| Author: | bbb [ Fri Sep 16, 2011 1:29 pm ] |
| Post subject: | Re: 35 GDSD |
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|