My guess is you found out for yourself. Aside from the engine actually running it has everything to do with speed.
Sand+props=Devil.
| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| worn down prop http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=23077 |
Page 1 of 1 |
| Author: | torrey w [ Thu Oct 13, 2011 8:49 pm ] |
| Post subject: | worn down prop |
How bad could a worn down prop effect speed? I have a 2007 MB 23 mini. And after running the river of course finding a few sand bars hard i noticed on the lake that im only running around 10 mph vs the 21 mph with about the same loads. 2 guys 2 dozen dekes and other small gear in a 1648 alumacraft jon. Or do i have something else going on. Thanks Torrey |
|
| Author: | POKER1 [ Thu Oct 13, 2011 8:52 pm ] |
| Post subject: | Re: worn down prop |
My guess is you found out for yourself. Aside from the engine actually running it has everything to do with speed. Sand+props=Devil.
|
|
| Author: | BoatDR [ Thu Oct 13, 2011 8:52 pm ] |
| Post subject: | Re: worn down prop |
| Author: | torrey w [ Thu Oct 13, 2011 9:01 pm ] |
| Post subject: | Re: worn down prop |
Rpms seem to be aboat the same but from what i read they are a little higher then most at 4100 in water and the over all length is 9.5 inches and one blade is like 5 inches or little under wide. Just wanted to make sure before i tried to order one. Any suggestions on what i should get and best place to order from not sure if there is a dealer near me Thankd |
|
| Author: | BoatDR [ Thu Oct 13, 2011 9:04 pm ] |
| Post subject: | Re: worn down prop |
MB only offers 1 prop for the mini, an 11x10. However you need to remove it and see if you have a hex or threaded shaft. And where are you? |
|
| Author: | torrey w [ Thu Oct 13, 2011 9:05 pm ] |
| Post subject: | Re: worn down prop |
Mankato, mn |
|
| Author: | BoatDR [ Thu Oct 13, 2011 9:11 pm ] |
| Post subject: | Re: worn down prop |
You'd have to call MB to find out who is the closest. The only dealer I know of in that region is in Lacrosse. If you want his info pm me. |
|
| Author: | torrey w [ Thu Oct 13, 2011 9:38 pm ] |
| Post subject: | Re: worn down prop |
Thanks i will try to call mudd buddy agaun tomorrow tried today |
|
| Author: | Mag10 [ Fri Oct 14, 2011 12:06 pm ] |
| Post subject: | Re: worn down prop |
Order it straight from Mud Buddy. It will be easier than trying to find someone around So. Mn. Sent you a PM Mag10 |
|
| Author: | ironman_gq [ Mon Oct 17, 2011 12:03 pm ] |
| Post subject: | Re: worn down prop |
I think Backwater is in MN, they make props and motors, might be able to help you out |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|