| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| MB Shaft Lenght http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=28976 |
Page 1 of 1 |
| Author: | DUCK HEARSE [ Fri May 04, 2012 5:38 am ] |
| Post subject: | MB Shaft Lenght |
I have a 35MB with 27 inch shaft which has cracked. I was wondering when I replace it if I should go with a longer one for more performance? Either 32 or 40 just wondering. |
|
| Author: | BoatDR [ Fri May 04, 2012 8:12 am ] |
| Post subject: | Re: MB Shaft Lenght |
| Author: | craig [ Fri May 04, 2012 9:04 am ] |
| Post subject: | Re: MB Shaft Lenght |
Down here anything longer than 27 just gets in the way. |
|
| Author: | DUCK HEARSE [ Fri May 04, 2012 2:47 pm ] |
| Post subject: | Re: MB Shaft Lenght |
I run mud and sand and a lot of veggie. Boat is 17x50 gtrax with huntdeck |
|
| Author: | dfou [ Fri May 04, 2012 2:57 pm ] |
| Post subject: | MB Shaft Lenght |
I recently switched to a 32" and I find it to be much better. I run everything from bottomless marsh to stumpy swamp |
|
| Author: | BoatDR [ Fri May 04, 2012 4:16 pm ] |
| Post subject: | Re: MB Shaft Lenght |
| Author: | Salty Dawg [ Fri May 04, 2012 5:24 pm ] |
| Post subject: | Re: MB Shaft Lenght |
I run a 40in shaft in nothing but hardpan bottoms and veggies... so far I have liked its... I'm sure a 32in would have been okay... but dam this thing is long from what I seen it can be trimmed up more than what the 27in could and never bounces on the bottom of the river anymore... prop saver for sure... since I upgraded my motor to spin High rpms it took all the tiller torque away at wot... but you better make sure you have a good hold of it when you drop the hammer down... |
|
| Author: | DUCK HEARSE [ Sat May 05, 2012 5:21 am ] |
| Post subject: | Re: MB Shaft Lenght |
Thanks for all the info. Looks like I might try the 32 |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|