pully problems



I have a go devil surface drive 23 horsepower. The crank case gasket started to leak oil, so i figured i would try and change it my self. Everything was goin good until i went to take the top drive pulley off. I dont see any set screws on the pulley and i took the two allen head bolts out of pulley. I tried three different wheel pullers doesnt wanna budge. Any thing im doin wrong? Any advise would be appreciated.

Put one of he Allen screws in the third threaded hole and tighten. When it's as tight as it will go, tap the pulley toward the engine.

gdsd23 thanks for asking this question and autogateman thanks for the perfect reply as I was having the same problem today and that thing came off like butter with your advice. thanks again.

Wish this would have seen this a few days ago. Didn't think I was ever going to get the top pulley off.

Hahaha. The fun part is getting it back on. IT always gives me more trouble....