The skeg on my 05 prodrive 32 is pretty loose. Rattles its ass off while running. Anyone know how these things mount? Replacement?

I wish that was the only problem i had, I'm fucking stuck, 300 yards from anything to hook the winch to...

Lol just bought the boat 2 weeks ago and noticed it last time out. Its still connected but it moves the motor side to side its so loose.

It snuck up on me...in the truck, put it in drive, get out and all fours turn...i might be here for a minute...

That's what pd guys are always screaming so it fit

You see these those Allen bolts on your skeg. Tighten those

take pictures of yours and post them.

Your skeg is worn from the vibration. The old style L/Us (like yours) uses the method of pulling each side the slot to hold/clamp the skeg in place it will only pull so far, the newer style uses the bolts nut. If you skeg is still in decent shape on the bottom . I would remove it and insert some calking or silicone in the slot reinstall the skeg and bolts ( but don't tighten it yet) wipe off the excess, let it cure then tighten it back down. If you have the spare change I'd go with a new one.

Let me look my boy, I may have one laying around.

I found two.

My skeg has about a 2 inch hairline crack by the prop. I'm going to weld it and see how long that last. If not, I will be on the hunt for a new or used one.

Just let bayouboy build you a new one. U won't regret it

Bayou-- send me some pics and a price.

Mines and one other was cracked to! They all crack in same place cause of the hole drilled! x100 on the skeg from bayou boy! U won't regret it!

How much does bayou boy charge?

I sent a pm thanks