viewtopic.php?f=41&t=30212
a lot of good tips here...
| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| surface drive build http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=31360 |
Page 1 of 1 |
| Author: | mallardman123 [ Wed Aug 08, 2012 9:21 pm ] |
| Post subject: | surface drive build |
I am building a surface drive motor from a 27 hp b&s vertical shaft.. i am wondering how long do make the shaft that is going vertical. It is a tall transom boat. Any help greatly appreciated |
|
| Author: | Mag10 [ Thu Aug 09, 2012 11:34 am ] |
| Post subject: | Re: surface drive build |
Depends... what angle is your prop going to enter the water. How far do you want to be able to trim down. What angle is the transom of your boat. The length of that shaft would be one of the last things I would design in a project like this. |
|
| Author: | mallardman123 [ Thu Aug 09, 2012 3:00 pm ] |
| Post subject: | Re: surface drive build |
Thank you, this is my first mud motor build. |
|
| Author: | The Shafer [ Thu Aug 09, 2012 3:30 pm ] |
| Post subject: | Re: surface drive build |
viewtopic.php?f=41&t=30212 a lot of good tips here...
|
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|