| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Pro drive prop http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=32020 |
Page 1 of 1 |
| Author: | fredthewelder [ Sun Sep 02, 2012 1:34 pm ] |
| Post subject: | Pro drive prop |
Hi guys ok my cup looks almos gone on one side So I'm going to replace the prop first Q Where is cheapest place to order a new one on-line 2 nd Q is what is the measurement across tip to tip on a new prop so I can see how much loss I have Thnxs Bear |
|
| Author: | POKER1 [ Sun Sep 02, 2012 9:08 pm ] |
| Post subject: | Re: Pro drive prop |
From PD. Should be a little over 12 1/4" new. It can still be 12 1/4" in diameter and have lost its bite so from my experience overal diameter is not key to determining performance loss. |
|
| Author: | fredthewelder [ Mon Sep 03, 2012 8:30 am ] |
| Post subject: | Re: Pro drive prop |
Thnxs I know it's lost it's bit for sure |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|