| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| PD Lower Unit Grease http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=41447 |
Page 1 of 1 |
| Author: | Wilson [ Wed Jun 05, 2013 6:53 pm ] |
| Post subject: | PD Lower Unit Grease |
How often do you grease the newer style Prodrive lower units? Specifically the zero right above the cav plate that makes grease come out by the prop. |
|
| Author: | T-Bubba [ Wed Jun 05, 2013 7:38 pm ] |
| Post subject: | Re: PD Lower Unit Grease |
i grease mine often.. i run alot of lillies that get stuck around the prop and cut the seals every time i pump grease water comes out... even after the first ride |
|
| Author: | K'jun [ Wed Jun 05, 2013 8:17 pm ] |
| Post subject: | Re: PD Lower Unit Grease |
This is a stupid question, but do you pump in that grease sert till grease comes out by prop? If not how many shots do you pump in at a time? |
|
| Author: | T-Bubba [ Wed Jun 05, 2013 9:35 pm ] |
| Post subject: | Re: PD Lower Unit Grease |
i pump it till grease comes out a good bit to flush it |
|
| Author: | Will [ Thu Jun 06, 2013 3:41 am ] |
| Post subject: | Re: PD Lower Unit Grease |
| Author: | K'jun [ Thu Jun 06, 2013 6:26 am ] |
| Post subject: | Re: PD Lower Unit Grease |
So I'm assuming here, theres no seal around the prop shaft that will be blown out if i keep pumping grease till i see it? |
|
| Author: | Will [ Thu Jun 06, 2013 6:28 am ] |
| Post subject: | Re: PD Lower Unit Grease |
Correct |
|
| Author: | pooldoo73 [ Thu Jun 06, 2013 2:01 pm ] |
| Post subject: | Re: PD Lower Unit Grease |
There are seals around the prop shaft, but they won't get blown out when u squeeze it. |
|
| Author: | bayouboy [ Fri Jun 07, 2013 10:17 am ] |
| Post subject: | Re: PD Lower Unit Grease |
I purge mine every 50 hrs or so, by removing the bottom plug on the prop shaft and pump grease until it comes out clean. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|