| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| bearing behind lower seal on 08 PD http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=60290 |
Page 1 of 1 |
| Author: | wireworks [ Sat Feb 21, 2015 6:56 pm ] |
| Post subject: | bearing behind lower seal on 08 PD |
Lower unit oil looked like thick chocolate milk and it was way over full, so I ordered a new lower seal. Removed the lower seal today and just doing a little checking, I tried shaking the shaft and noticed that there was a small amount of movement at the bearing behind the seal. Not much, but you could tell that it was not solid. Is this a big problem or normal and if a problem, have any of you had it? It had been setting for several days before I checked it, so not air. I did change the oil and ran it about an hour fishing and let it set for a couple of days and it was the same thing only not as thick and was just a little over full. |
|
| Author: | oleman [ Mon Mar 02, 2015 12:25 pm ] |
| Post subject: | Re: bearing behind lower seal on 08 PD |
I have a 08 PD, brought the lower unit to PD for the retrofit kit which puts a seal after the gear box and it helped. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|