|
|
FAQ
• Login
|
|
It is currently Sun May 11, 2025 2:44 pm
|
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
chevy01
MMT Pro Member
Joined: Thu Jul 04, 2013 6:44 pm
Posts: 105
Location: orlando fl
|
 Mudbuddy pulley? I have a stock 35 HD and did some mods. According to mudbuddys page they come stock with a 38/50 tooth pulley so I bought a 48t tore it down and seen it has a 36/47 tooth has any one ran into this and if I was to install the 48 I would gain bottom end correct?
Sent from my iPhone using Tapatalk
_________________
1648 G3 2013 mudbuddy 35
|
| Thu Nov 26, 2015 10:56 am |
|
|
|
deadbird8
MMT 1000 Club
Joined: Wed Feb 04, 2009 7:50 pm
Posts: 3833
Location: Old East Dallas, Texas
|
Re: Mudbuddy pulley? With the 36 tooth top you are pretty much stuck with one adjustment to lower the gear ratio- you can only go to a 46 tooth bottom which will move you to 1:28- the lowest you can go with what they have available that I know of. This will only drop your RPM about 2% going from a 47 to 46.
Most come with a 38 tooth clutch gear that allows a lot more adjustment (i.e. the 48 tooth would have got you to 1:26 and drop your RPM ~4%).
_________________
Excel 1851F4 w/ MB35HD+R CDI with a little bit of this and little bit of that
|
| Sat Nov 28, 2015 4:48 pm |
|
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: Google [Bot] and 89 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
