I know a couple people who would want the output shaft from it.
| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Prodrive lower unit issues http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=68332 |
Page 1 of 1 |
| Author: | justin_plauche5 [ Tue Sep 20, 2016 12:58 pm ] |
| Post subject: | Prodrive lower unit issues |
My drain plug on my short transom 27hp gen1 lower unit broke in the water and my bearings locked up. if I have to replace the whole lower unit can any lower unit fit (Gen2, Gen3, Gen4)? |
|
| Author: | brycecheramie [ Thu Sep 22, 2016 7:26 am ] |
| Post subject: | Re: Prodrive lower unit issues |
Yes, and make sure to get the Gen 4. Don't go with Gen 3 Are you sure the Bearings are indeed locked up? I know a few people on here who would get that from you just to bust it open. |
|
| Author: | cb5331 [ Thu Sep 22, 2016 8:14 am ] |
| Post subject: | Re: Prodrive lower unit issues |
I know a couple people who would want the output shaft from it.
|
|
| Author: | justin_plauche5 [ Thu Sep 22, 2016 12:30 pm ] |
| Post subject: | Re: Prodrive lower unit issues |
took it apart yesterday and it's something under my clutch and above my top gear. outdrive shaft is perfectly fine except minor tooth chips. Would I have to get a different adaptor If I go with the gen4? |
|
| Author: | brycecheramie [ Thu Sep 22, 2016 1:41 pm ] |
| Post subject: | Re: Prodrive lower unit issues |
| Author: | dead animal [ Thu Sep 22, 2016 7:05 pm ] |
| Post subject: | Re: Prodrive lower unit issues |
if your spline adaptor is bad just change it and move on. easy fix. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|