Not unless you like dudes too
| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| What size prop? DIY -ish Surface Drive http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=68775 |
Page 1 of 1 |
| Author: | rotten_1 [ Fri Oct 28, 2016 7:19 pm ] |
| Post subject: | What size prop? DIY -ish Surface Drive |
After trolling on this fourm and scouring the DIY sections i decided to build a surface drive with parts and pieces. First I found a 27" Mud Buddy lower, picked up a Predator 670 motor new, and crashed McMaster & Car. So... after fabricating a housing for the MB lower and started fabricating a transom mount, the last piece I need is a prop. Specs are as followed: Predator 670 Upper gear - 36 tooth 101.6mm Lower Gear - 45 tooth 124.46mm Gates 8m-1440-20 gt timing belt MB 27" lower What prop would optimize the gears and motor combo. Boat is a Xpress 1650 with foam still in it. (will be removed after this duck season) Thanks for all the information. Sent from my SM-G920V using Tapatalk |
|
| Author: | flint87 [ Fri Oct 28, 2016 8:47 pm ] |
| Post subject: | Re: What size prop? DIY -ish Surface Drive |
Man why would you admit to trolling us and then ask for help. Maaaaaaaan. Sent from my iPhone using Tapatalk |
|
| Author: | rotten_1 [ Fri Oct 28, 2016 9:32 pm ] |
| Post subject: | Re: What size prop? DIY -ish Surface Drive |
crap, i'm out of the loop... NOT trolling: "make a deliberately offensive or provocative online posting with the aim of upsetting someone or eliciting an angry response from them." I meant "cruising". or does that mean something else also? Sent from my SM-G920V using Tapatalk |
|
| Author: | SETx Longtail [ Sun Oct 30, 2016 8:02 pm ] |
| Post subject: | Re: What size prop? DIY -ish Surface Drive |
Not unless you like dudes too
|
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|