MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
Need help getting my prop off!! http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=71763 |
Page 1 of 1 |
Author: | vette1986 [ Wed Dec 20, 2017 4:23 pm ] |
Post subject: | Need help getting my prop off!! |
Hey guys this is my 1st mud motor and it's time to Change the prop. I just bought a new prop from bps and I thought I would remove mine before it gets here. I got the bottom that off with my impact wrench but I cannot get this prop to budge at all. Not even some wacks with a hammer help. What am I doing wrong? Are there any tricks for getting these off as I know be pretty tight being threaded. The engine is a marsh monster which is pretty much like to go devil beaver tail set up. |
Author: | bluesky2012 [ Wed Dec 20, 2017 4:38 pm ] |
Post subject: | Re: Need help getting my prop off!! |
PB Blaster would be where I start Sent from my iPhone using Tapatalk Pro |
Author: | vette1986 [ Wed Dec 20, 2017 5:43 pm ] |
Post subject: | Re: Need help getting my prop off!! |
Went and bought some and a couple more whacks and it came off. Thanks! |
Author: | Koondog62 [ Thu Dec 21, 2017 3:59 am ] |
Post subject: | Re: Need help getting my prop off!! |
Maybe put some anti seize on it before putting back on? What y'all think good idea or not? If not please explain why. |
Author: | Johnny-O [ Thu Dec 21, 2017 9:51 am ] |
Post subject: | Re: Need help getting my prop off!! |
Author: | DENNYEDWARDS [ Thu Dec 21, 2017 10:19 am ] |
Post subject: | Re: Need help getting my prop off!! |
Using a dead blow hammer will work to loosen prop, but have seen bearing races cracked from excessive hammering. Might want to build your self a prop removal bar and use torque to un thread prop. Have seen a cracked race lock up a prop shaft and ruin the shaft. |
Author: | Smoke [ Thu Dec 21, 2017 11:09 am ] |
Post subject: | Re: Need help getting my prop off!! |
Author: | BlueShamu [ Thu Dec 21, 2017 11:18 am ] |
Post subject: | Re: Need help getting my prop off!! |
Author: | Koondog62 [ Fri Dec 22, 2017 5:52 am ] |
Post subject: | Re: Need help getting my prop off!! |
Ok thanks my motor is brand new I will pull the prop and put some on there. Was thinking about that anyhow. Thanks for the responses. |
Page 1 of 1 | All times are UTC - 6 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |