| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| Need a spline adapter http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=41&t=73380 |
Page 1 of 1 |
| Author: | med [ Thu Dec 27, 2018 1:04 pm ] |
| Post subject: | Need a spline adapter |
I have a gen1 pd (2006 36) and recently had the lu go out. I’m replacing with a gen3 lower and need a different spline adapter. I’m assuming due to the different shaft length. Anyone happen to have one laying around they would sell that would fit this application ? Pd doesn’t have one in stock and the machinist is going to have to cut one down a respline it. That would be fine but he’s on vacation until next Wednesday  . Just trying to decrease my downtime if possible.Thx |
|
| Author: | dead animal [ Thu Dec 27, 2018 6:56 pm ] |
| Post subject: | Re: Need a spline adapter |
I know it sucks to wait, but wait and get a new one. a old worn one will just wear your shaft on the 'new' lower unit faster. 'just my .02, I may be wrong' |
|
| Author: | Wchauvin [ Thu Dec 27, 2018 8:52 pm ] |
| Post subject: | Re: Need a spline adapter |
I agree with dead animal |
|
| Author: | med [ Thu Dec 27, 2018 10:12 pm ] |
| Post subject: | Re: Need a spline adapter |
10-4. Guess I’m gonna have to start fishing so if there’s an issue I can get it taken care of before hunting season |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|