| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| jackplate question http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=5&t=27996 |
Page 1 of 1 |
| Author: | RScar87 [ Wed Mar 28, 2012 5:28 am ] |
| Post subject: | jackplate question |
I'm buyin a hd16ddp xpress and the transom height is 21" and I got a short shaft 35 GTR and I was goin to put the jackpot on it and drop it done... Has anybody done it? Will it work? |
|
| Author: | eljefe [ Wed Mar 28, 2012 5:33 am ] |
| Post subject: | Re: jackplate question |
Gonna have to find a way that will allow motor to kick up without hitting transom....id say cut the transom down. |
|
| Author: | RScar87 [ Wed Mar 28, 2012 6:38 am ] |
| Post subject: | Re: jackplate question |
I was gone do that but I would think that the jackplate would work better.... Idk |
|
| Author: | eljefe [ Wed Mar 28, 2012 8:54 am ] |
| Post subject: | Re: jackplate question |
if you drop the motor with a jack plate, will the motor hit the transom when it kicks up? there are a lot of options...cutting down transom or adding a hunt deck, but when I was looking to putting my pd on a jack plate to lower it a few inches when in mud, I was going to be hitting transom on the kick up....the only solution I came up with was cutting down transom and adding a mounting plate that was spit down the middle to accomidate trim etc.....but I still dont know if motor would have kicked up and hit jack plate supports when fully lowered...... |
|
| Author: | wabbit-hunter [ Fri Mar 30, 2012 5:16 pm ] |
| Post subject: | Re: jackplate question |
cut the transom down |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|