Guys im trying to change all the seals on my shaft, upper and lower. and i ran into a snafoo with the upper ones. I got my yoke apart and got the ujoint out (after breaking the grease zerk off). I cant get the seals off the upper and the manual is confusing me. Its telling me to cut all kinda stuff off. Can yall please help with me out with this snafoo.?? any help is appreciated!! thanks guys.

I'm not familiar with your setup, but looking at the pics you posted I'd say you have 2 options.

1.) remove the bearing that hendering you from removing the seals.

2.) remove the engine and slide the whole shaft out and remove the seals.


Hope this helps.

Bearing doesnt budge, tried. Engine is an option but want to avoid that if possible.

That bearing might have a set screw or 2.

i looked around, didnt see anything. I might have to go swing by the local go-devil shop tomorrow to figure this one out..

Ya better hurry the seasons about to open!!!!!!!!!! lol

ima tryin!

SUCCESS!!!.....after bjg came over with a die grinder and we cut it off