| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| HELP needed asap! http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=6&t=5992 |
Page 1 of 1 |
| Author: | CypressIslandBoyy [ Thu Nov 12, 2009 6:06 pm ] |
| Post subject: | HELP needed asap! |
Guys im trying to change all the seals on my shaft, upper and lower. and i ran into a snafoo with the upper ones. I got my yoke apart and got the ujoint out (after breaking the grease zerk off). I cant get the seals off the upper and the manual is confusing me. Its telling me to cut all kinda stuff off. Can yall please help with me out with this snafoo.?? any help is appreciated!! thanks guys. |
|
| Author: | bayouboy [ Thu Nov 12, 2009 6:21 pm ] |
| Post subject: | Re: HELP needed asap! |
I'm not familiar with your setup, but looking at the pics you posted I'd say you have 2 options. 1.) remove the bearing that hendering you from removing the seals. 2.) remove the engine and slide the whole shaft out and remove the seals. Hope this helps. |
|
| Author: | CypressIslandBoyy [ Thu Nov 12, 2009 6:27 pm ] |
| Post subject: | Re: HELP needed asap! |
Bearing doesnt budge, tried. Engine is an option but want to avoid that if possible. |
|
| Author: | bayouboy [ Thu Nov 12, 2009 6:37 pm ] |
| Post subject: | Re: HELP needed asap! |
That bearing might have a set screw or 2. |
|
| Author: | CypressIslandBoyy [ Thu Nov 12, 2009 6:41 pm ] |
| Post subject: | Re: HELP needed asap! |
i looked around, didnt see anything. I might have to go swing by the local go-devil shop tomorrow to figure this one out.. |
|
| Author: | bayouboy [ Thu Nov 12, 2009 6:46 pm ] |
| Post subject: | Re: HELP needed asap! |
Ya better hurry the seasons about to open!!!!!!!!!! lol |
|
| Author: | CypressIslandBoyy [ Thu Nov 12, 2009 6:48 pm ] |
| Post subject: | Re: HELP needed asap! |
ima tryin! |
|
| Author: | CypressIslandBoyy [ Sat Nov 14, 2009 4:30 pm ] |
| Post subject: | Re: HELP needed asap! |
SUCCESS!!!.....after bjg came over with a die grinder and we cut it off |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|