It is currently Fri Mar 29, 2024 6:09 am




Reply to topic  [ 2 posts ] 
 Stuck shaft 
Author Message
MMT Member

Joined: Fri Aug 07, 2015 9:08 am
Posts: 3
Post Stuck shaft
I was in the process of replacing my lower seals when I found that corrosion has gotten the best of my engine. I couldn't remove the prop without a lot of heat and then the seal was corroded to the bearing housing. We were finally able to get the seal free, and tried to disconnect the shaft from the U joint but weren't able to make that move. We ended up cutting the shaft below the U joint to try and at least get the shaft out. I removed the restraining clip and the shaft seems to move pretty easily but won't budge outward. Any suggestions would be greatly appreciated. Also, do the bearing housings come off the shaft tube? And if so, do they screw on or press on?

Sent from my SM-G955U using Tapatalk


Sat Aug 19, 2017 8:10 am
Profile
MMT Member

Joined: Fri Aug 07, 2015 9:08 am
Posts: 3
Post Re: Stuck shaft


Thu Aug 24, 2017 7:37 am
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 2 posts ] 

Who is online

Users browsing this forum: No registered users and 127 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: