| MudmotorTalk.com http://www.mudmotortalk.com/mmt_v2/ |
|
| removing planetary gear/ shaft extension http://www.mudmotortalk.com/mmt_v2/viewtopic.php?f=7&t=69649 |
Page 1 of 1 |
| Author: | swordfish [ Thu Jan 26, 2017 7:43 pm ] |
| Post subject: | removing planetary gear/ shaft extension |
Does the shaft extension come off once the outer planetary gear is removed? can figure out what is holding it on. Secondly, I am Having a lot of trouble getting the allen bolts free from inside the outer planetary gear. Any advice? I was considering getting a decent impact wrench but wanted to see if there were any other options. |
|
| Author: | Russ [ Thu Jan 26, 2017 9:28 pm ] |
| Post subject: | Re: removing planetary gear/ shaft extension |
It just has a key, and it's a nice snug fit. I used a rubber mallet, tap all the way around on the end, it'll eventually work it's way off. Notice I used the word tap. Think finishing nail through drywall into a stud, not using a sledge through drywall in preparation to remodel. It doesn't take alot, just a few loops around it until it either falls off or you can pull it the rest of the way by hand. Make sure and use antiseize for reassembly. |
|
| Author: | swordfish [ Fri Jan 27, 2017 2:43 am ] |
| Post subject: | Re: removing planetary gear/ shaft extension |
| Author: | Russ [ Fri Jan 27, 2017 4:53 am ] |
| Post subject: | Re: removing planetary gear/ shaft extension |
Yep. |
|
| Page 1 of 1 | All times are UTC - 6 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|