|
|
FAQ
• Login
|
|
It is currently Sat Jul 19, 2025 11:37 am
|
|
Page 1 of 1
|
[ 6 posts ] |
|
| Author |
Message |
|
backwaterballer
MMT Addict
Joined: Sat Feb 21, 2009 9:39 pm
Posts: 715
Location: Pearland Tx
|
 Linkage spring set up Can someone post a pic of the spring setup on the back of a 35 hp
_________________
23 hp gdlt pushin the 14ft NoWeld "aka" the black pearl
35 hp gdsd pushin a 16/60 go devil boat
|
| Thu Apr 07, 2011 7:36 pm |
|
|
|
deadbird8
MMT 1000 Club
Joined: Wed Feb 04, 2009 7:50 pm
Posts: 3833
Location: Old East Dallas, Texas
|
Re: Linkage spring set up
_________________
Excel 1851F4 w/ MB35HD+R CDI with a little bit of this and little bit of that
|
| Thu Apr 07, 2011 8:05 pm |
|
|
|
backwaterballer
MMT Addict
Joined: Sat Feb 21, 2009 9:39 pm
Posts: 715
Location: Pearland Tx
|
Re: Linkage spring set up Thanks bro im fo sho missing a spring
_________________
23 hp gdlt pushin the 14ft NoWeld "aka" the black pearl
35 hp gdsd pushin a 16/60 go devil boat
|
| Thu Apr 07, 2011 8:35 pm |
|
|
|
deadbird8
MMT 1000 Club
Joined: Wed Feb 04, 2009 7:50 pm
Posts: 3833
Location: Old East Dallas, Texas
|
Re: Linkage spring set up Long spring for throttle return is a MB part.
_________________
Excel 1851F4 w/ MB35HD+R CDI with a little bit of this and little bit of that
|
| Fri Apr 08, 2011 5:15 am |
|
|
|
GDLT31
MMT Pro Member
Joined: Mon Jan 26, 2009 12:27 am
Posts: 85
Location: Lady Lake,Fl.
|
Re: Linkage spring set up I see that on your motor that the small spring is in the upper position,on my motor it is just below the purple spring.Is there a reason for this.My motor will free rev 4550rpm and when it hits the water 3350rpm is all I can get.I have bought springs,adjusted tabs until i'm blue in the face.Any help would be greatly apprecited.
|
| Sun Apr 17, 2011 10:52 pm |
|
|
|
deadbird8
MMT 1000 Club
Joined: Wed Feb 04, 2009 7:50 pm
Posts: 3833
Location: Old East Dallas, Texas
|
Re: Linkage spring set up Those pics are the spring setup on a 35, not sure why yours is different but you should try to copy them and see if it solves your problem.
_________________
Excel 1851F4 w/ MB35HD+R CDI with a little bit of this and little bit of that
|
| Tue Apr 19, 2011 3:56 pm |
|
|
|
|
|
Page 1 of 1
|
[ 6 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 88 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
