Got the lights mounted and wired inspired by MMT user Will. I Used the old GT Baja light bracket and plug ( I knew it would come in handy one day). The switches are located in my rocker panel in rear driver box. All I have to do is slide the bracket in, plug them in and flip a switch (or two depending on what light combo I want). I isolated the circuits where I can use these lights in the following combination all from one plug:


1. D2 pair
2. Dually Spot
3. D2 pair + Dually Spot


When I am done with them I simply unplug and store them. I decided not to go with the light bar for multiple projection options you do not get with the 10" light bar. This combo puts out more light than the 10" light bar by Rigid Industries standards and specs.


As for performance: WOW!


Good luck finding any HID set that can even come close. I am sure there are some other LEDs that are out there that can compete, but I would like to see them side-by-side. I will try to post some nights shots soon.

What kinda panel do you have?

That's a nice rig there

Damn... That is @$500 in lights. I find that I use my hardhat light more than my dual $100 HID setup on the bow.

Y'all have any night pics of them

Hopefully I will get some soon. Other than just shining them down my road in the subdivision. They are so bright I am trying not to upset the neighbors.

Until then here is a video of the just the Dually D2 pair driving beam without the Dually spot in the middle.

Pics of lights from boat on water?

Are the D2's the flood lights? I ordered a pair of dually flood lights yesterday. Just wondering what to expect.

All three of them are Duallys. The two outside lights are Dually D2s and are the wide driving pattern. The middle is the Dually (NOT D2) spot pattern.

$400.00 for all three lights.

Your english sucks dick

I think he is talking about the video haha

So how do they work? Trying to decide on the dually flood or spot.

If you were just going to do 2 of them, which ones would you choose?

The Dually D2 Driving (Wide) pattern

I know this is an extremely old thread and I probably have a slim chance of hearing a response but how did you get the lights to work where you can select which light combo you want on? I am thinking about going a similar route as this except with the 6" E2-Series Hyperspot.

four position switch