Hi,

Several posts point me towards mcmaster.com for grease seals, but there are about a dozen choices on the site.

Which type of grease seals do I need to match with brass bushings?

Thanks,
Kendall

if it was me i would get away from lip seals all together and get you a bearing isolater (inpro). no contacting parts, reuseable, never need to replace.

Thank you for the reply.

Reading between the lines, are lip seals what I need to go with brass bushings?

Can you point me in the direction of a bearing isolator, I would like to check out that option.

Thanks again,
Kendall

Kendall, you cannot use bearing isolators on a mud motor. You must use a lip seals to hold water out.
You need to know your shaft diameter and the bore you wish to press the seal into.http://www.timken.com/en-us/products/se ... ature.aspx

OlSchool,

Thank you, your help is appreciated.

Have a great day,
Kendall