Might as well work the extra set I have.

I have 12 sets to do

Def would use kirt vice befor clamping on table directly Hope you indicated them as we'll

A vice sure would have been easier. Had better luck clamping to the table than I did with the vice. Plus I didn't want to do one at a time. I guess I could have put two vices on the table side by side but just figured that'd be even more set up time.

True done once done right

Good lil set up

Cut these .040. Great finish with slow feed and high speed. Also when done ran the heads over 600 grit on the rock (granite) table. Now I just have to port and polish.

Nice. That'll do it. These heads have zero hours on them so I am only gonna lap the valves in. Probably throw in some ss valves and a 3 angle valve job when they get some time on them. Gonna let one of my buddies run these on a stock motor. Should bump up his load carrying capabilities pretty good.

Yea mine are decked .035 stainless valves and laped And port and polish Lots or extra power

What bouts y'all find the ss valves to put in them?

You mean pvt?